T+A MP 200 User Manual

Select letter / number / symbol
Select letter / number / symbol
Next digit
Delete previous
digit
Apply entry
System settings
Source
conguration
At this menu item you can activate and disable not used sources, and assign a plain text
name to each source; this name then appears in the screen displays.
You can also assign a plain text name for the display to the external sources (digital in-
puts and Bluetooth).
When this menu item is called up with the button, a list of all sources of the MP 200
appears.
Each source is followed by the displayed plain text name or the note Enabled for an
active source or Disabled if the source is deactivated.
Deactivate not required sources
A long press on the button deactivates the selected source.
To activate a source, press the button briey.
Change the source name
To change the plain text name, rst select the corresponding source and press the
button.
Delete the previous name by repeatedly pressing the button.
Enter the new name using the cursor keys.
To switch between numeric and alphanumeric input as well as upper/lower case, press
the button.
If you should wish to restore the factory default source name, erase the whole name
before saving the empty eld with the button: this action resets the display to the
standard source names.
j
These settings can only be changed by using the remote control.
Display brightness
At this point you can adjust the brightness of the integral screen to suit your personal
preference for normal use.
Display mode
Here you can set whether the display will be switched on permanently or only tempora-
rily, when the device is being operated.
If the setting temporary is selected, the display is switched on during operation of the
MP 200 only and then automatically switched off again after a short delay.
If the Always ON setting is selected, the display remains permanently on.
28

T+A MP 200 Specifications

General

Brand	T+A
Model	MP 200
Category	Stereo System
Language	English