EasyManua.ls Logo

Tracker Off-Road 300 - Tips for Specific Situations

Tracker Off-Road 300
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
2. Approach the obstacle head-on.
3. Come up off the seat.
4. Keep your weight on the footrests.
5. Apply a little throttle when the front
tires make contact with the obstacle.
6. Lean forward and release the throttle
when the front tires clear the obstacle.
7. Keep your body loose to absorb any
shock.
8. If the ATV starts tipping, shift your
weight to keep it in balance.
To clear a single-track (only one tire contact-
ing) obstacle, follow the same rules except:
1. Use the ATV’s momentum to clear
the obstacle.
2. Don’t pull up on the handlebar.
3. Don’t apply the throttle.
Driving an ATV and a car have some
similarities; however, there are a few sit-
uations that require special attention:
Reversing
Skidding or Sliding
Parking on a Hill
Stalling on a Hill
•Crossing Water
Crossing Roads
Stopping the ATV
Stopping the Engine
Reversing
It’s tough to see things behind you.
1. Go slowly. It’s hard to see behind
you.
2. Keep your handlebar straight.
3. Backing down hills is a bad idea; do
a U-turn or K-turn instead to turn
around.
Skidding or Sliding
If you lose control after hitting sand, ice,
mud, or water:
1. Turn your handlebar into the direc-
tion of the slide.
2. Keep your hand off the brakes until
you’re out of the skid.
3. Shift your weight forward.
Sometimes your ATV may not respond
and goes straight ahead instead of letting
you turn. Here’s how to handle it:
1. Slow down.
2. Move forward on the seat.
3. Lean to inside of turn.
4. Turn handlebar.
Parking on a Hill
This shouldn’t be necessary, but if it is:
1. Keep it in gear.
2. Engage the brake lever lock.
3. Find something to block the rear
tires.
Stalling on a Hill
If you use the right method for riding
uphill, this shouldn’t happen. But if you
have a problem, do this:
1. If the ATV hasn’t started rolling
backwards yet, follow the proce-
dure for the K-turn, OR
2. If the ATV is already rolling back-
ward, lean as far forward as possible
standing up on the footrests.
3. Nice and easy, apply the front and
rear brakes.
4. When you come to a stop, follow the
procedure for the K-turn.
5. If the ATV continues to roll back-
ward, dismount immediately on the
uphill side.
Tips
! WARNING
Never activate the override while the
throttle is open as a loss of control
may result. Use caution when using
the override switch as reverse speed
can greatly increase.

Table of Contents

Related product manuals