Trademaster WE-350DS - Default Chapter; Table of Contents

- 1 -
Contents
Chapter 1
ACCIDENT PREVENTION AND SAFETY
REGULATION
1.1 Advice for the operator .........................................2
1.2 The electrical equipment according to European
Standard" CENELEC EN 60 204-1" (1992)................2
1.3 Emergencies according to European Standard
“CENELEC EN 60 204-1 (1992)”................................2
Chapter 2
MACHINE DIMENSIONS TRANSPORT
INSTALLATION DISMANTLING
2.1 Machine dimensions.............................................2
2.2 Assembling the Saw and the Base.......................2
2.3 Minimum requirements for housing the machine..3
2.4 Anchoring the machine.........................................3
2.5 Instructions for assembly of the loose parts and
accessories.................................................................3
2.6 Deactivation of machine .......................................3
2.7 Dismantling...........................................................3
Chapter 3
THE MACHINE’S FUNCTIONAL PARTS
3.1 The saw arm.........................................................3
3.2 Controls.................................................................4
3.3 Vice adjustment ....................................................4
3.4 Cutting angle adjustment......................................5
3.5 The base...............................................................5
3.6 Saw frame return stroke-limiting device ...............5
3.7 The operation cycle ..............................................5
Chapter 4
ADVICE ON USING YOUR BANDSAW
4.1 Recommendations and advice for using the
machine ......................................................................6
Chapter 5
ADJUSTING YOUR MACHINE
5.1 Blade tension assembly........................................7
5.2 Adjusting the blade guide .....................................7
5.3 Changing the blade...............................................7
5.4 Adjusting the blade to the flywheels .....................8
Chapter 6
ROUTINE AND SPECIAL MAINTENANCE
6.1 Daily maintenance................................................8
6.2 Weekly maintenance ............................................ 8
6.3 Monthly maintenance ...........................................8
6.4 Six-monthly maintenance..................................... 8
6.5 Maintenance of other machine parts....................8
6.6 Oils for lubricating coolant.................................... 8
6.7 Oil disposal........................................................... 9
6.8 The gear box ........................................................9
6.9 Special maintenance ............................................ 9
Chapter 7
TECHNICAL CHARACTERISTICS
7.1 Table of cutting capacity and technical details..... 9
Chapter 8
MATERIAL CLASSIFICATION AND CHOICE OF
TOOL
8.1 Definition of materials......................................... 10
8.2 Selecting blade...................................................10
8.3 Teeth pitch..........................................................10
8.4 Cutting and advance speed................................ 10
8.5 Blade running-in .................................................10
8.6 Blade structure ...................................................10
8.7 Blade type........................................................... 11
Chapter 9
NOISE TESTS..........................................................11
Chapter 10
WIRING DIAGRAM.................................................. 12
Chapter 11
TROUBLESHOOTING
11.1 - Blade and cut diagnosis.................................13
11.2 - Electrical components diagnosis.................... 17
Chapter 12
MACHINE COMPONETS
12.1 Parts list............................................................ 18
12.2 Explosion drawings........................................... 21