BlueTOAD Spectra RSU Deployment
TrafficCast Quick Start—BlueTOAD Spectra and Spectra RSU
3-18 Revision 02 May 2019
2. Guidelines to route and connect the cables:
a. Traffic Closure—Close traffic lanes as necessary to pull cable.
b. CAT-5 Ethernet Cable
i. Pull the main CAT-5 Ethernet Cable through the roadside conduit from the roadside
cabinet to the RSU enclosure.
ii. Connect the Ethernet cable to the PoE 48 VDC Connector on the bottom of the RSU
enclosure.
Note: The PoE 48 VDC connector goes to the PoE Splitter that also sends data
from the Spectra RSU to the PoE Injector inside the cabinet.
Important: To seal the antenna connectors against rust and corrosion, protect them
per the Required Best Practice instructions shown below.
To Next Page
Loading...