BlueTOAD Spectra RSU Deployment
TrafficCast Quick Start—BlueTOAD Spectra and Spectra RSU
3-20 Revision 02 May 2019
c. Install the PoE Injector in the roadside cabinet:
i. Secure the PoE injector onto a flat surface inside the roadside cabinet.
Note: The PoE Injector has two RJ-45 ports:
• Data—connects to the network Ethernet switch, router or hub
• Data and Power—connects to the PCB of the RSU, i.e. to the PoE Splitter
ii. Connect the ground wire.
iii. Connect the Main CAT-5 Ethernet Cable to the PoE Injector.
iv. Connect an Ethernet cable from the PoE Injector to the cabinet LAN/WAN Ethernet
Network Switch or Router.
v. Connect the Ethernet Network Switch to the Traffic Controller.
vi. Connect the AC Power Supply to the PoE Injector.
vii. Plug the 110 VAC cord into an AC power outlet receptacle.
Main CAT-5 Ethernet Cable
Ethernet Cable to Ethernet
Network Switch or Router
To Next Page
Loading...