Trane BACnet BCI-R User Manual

SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing
of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and
training. Improperly installed, adjusted or altered equipment by an unqualified person could result in death or
serious injury. When working on the equipment, observe all precautions in the literature and on the tags,
stickers, and labels that are attached to the equipment.
March 2011 BAS-SVP09B-EN
Integration Guide
BACnet
™
Communication Interface for
ReliaTel
™
Controllers (BCI-R)
P1
LED9
LED8
U1
654
C
B
A
321
D
F
G
H
E
U10
SW3
SW2
SW1
Q9
LED6
LED5
LED3 LED1
J1
J2
17
LED7
LED2LED4
J5
J3
-MT
0
5
1
2
3
4
6
7
8
9
0
5
1
2
3
4
6
7
8
9
9
8
7
6
4
3
2
1
5
0
2010.04
- MODBUS +
24VAC
-+
TX
RXRX
TX
ADDRESS SETTING
X100
X10 X1
LINK
SERVICE
MODBUS
STATUS
REV 02
6400-2563-01C 2010
TRANE
X NUMBER LABEL
BARCODE LABEL
IMC
BACNET
LINK
TERMINATOR
SERVICE
A1
A1
1-
1-
1-
1-
1-
1-
1
1-
1-
1-
1-
1-
1-
+
1-
+
1
ON
+
-
+
+
-

Trane BACnet BCI-R Specifications

General

Brand	Trane
Model	BACnet BCI-R
Category	Recording Equipment
Language	English

Summary

BACnet Communication Interface for ReliaTel Controllers (BCI-R)

Getting Started with BCI-R Integration

Required Software and Tools

Initial BCI-R Setup Tasks

Outlines the initial tasks in the correct order for setting up the BCI-R.

Setting Rotary Switch Addresses

Explains how to set the three-digit MAC address using rotary switches on the BCI-R.

Selecting Wired or Wireless Communication

Configuring the BCI-R Controller

Using the BACnet Setup Tool

Describes how to configure the BCI-R using the Tracer BACnet Setup Tool.

Using Tracer TU for Configuration

Details how to connect to and configure the BCI-R controller using Tracer TU software.

Understanding MAC Address and Device ID

Explains the relationship between rotary dial settings, MAC address, and BACnet Device ID.

Post-Installation Configuration Changes

Procedures for resetting the controller and updating application code after initial installation.

Clearing and Restoring Factory Defaults

Explains how to reset the BCI-R controller to its factory default settings.

Updating the Application Code

BCI-R Operation and Control

BAS Unit Control Overview

Explains how the BCI-R controls HVAC equipment as part of a building automation system.

Initiating System Control Commands

BCI-R LEDs and Switches

Interpreting LED Status and Switch Functions

BACnet Data Point and Property Definitions

BACnet Object Types and Properties

Defines and describes various BACnet object types, their properties, and configuration.

BACnet Protocol Details

Object Data Points and Diagnostics

Analog Output Data Points

Analog Input Data Points

Analog Input and Value Data Points

Multistate Output and Input Data Points

Binary Output and Input Data Points

Diagnostic Binary Input Data Points

Lists diagnostic binary input data points and their notification classes.

All Object Types by Name

Notification Classes and Diagnostic Objects