5
Section 3. Unit Preparation
3.1 Prepare The Unit For Installation
STEP 1 - Check for damage and report promptly to
the carrier any damage found to the unit.
Note: If the unit must be transported in a horizontal
position, it must be laid on its back (marked “REAR”
on carton).
Note: Remove the cardboard from the bottom of the
blower. Cut the tie wrap and remove the foam block
located at the motor.
Note: After the unit is removed from the carton,
release pressure from the coil to verify coil is
pressurized and leak free.
3.2 Unit Accessories
Accessory Number Description
Fits Cabinet Size ①
BAYECAA05LG1 Electric Heater, 5kW, Lugs, 24V Control, 1 Ph A1
BAYECAA08LG1 Electric Heater, 8kW, Lugs, 24V Control, 1 Ph A1
BAYECAA10LG1 Electric Heater, 10kW, Lugs, 24V Control, 1 Ph A1
BAYSFSCABAA Supply Duct Flange A1 ① A1
BAYRETFLGAA Return Duct Flange A A1
TASB175SB ④ Plenum Stand with integrated Sound Baffle 17.5” Cabinet A1
BAYICSKIT01 Internal Condensate Switch (Upflow Orientation Only) A1
BAYFRKIT100 Front Return Kit A1
BAYBRFBX100 Bottom Return Filter Box A1
BAYWMKIT001 Wall Mount Kit A1
BAYLVKIT100 Low Voltage Conduit Entry Kit A1
BAYATXV1836 R-22 TXV conversion kit 1-1/2 to 3 ton A1
BAYSRKIT100 Side Return Kit A1
BAYECPDKIT1 Pull Disconnect Kit A1
BAYBAFKT175A ③ Baffle Kit 17.5” Cabinet A1
BAYINSKT175A Sound Insulation Kit A1
BATCNDPIP01A 3/4” PVC Threaded Pipe Kit A1
BAYFLR1620A High Velocity Filter Kit, 16” x 20” x 1” (10 filters) A1
TASSBK175 ②④ Sound Baffle Kit 17.5” Cabinet A1
MTISRKIT1620 ④ Side Return Kit with 16"x20" Filter A1
BAYCNDPIP01A 3/4” PVC Threaded Pipe Kit foam seal (10 per box) A1
① GAF2A0A36M Cabinet is one piece A1, 17.5” wide
② Mounts to older TASB175 plenum stands with no integrated baffle
③ Mounts in air handler filter channel
④ Contact your distributor for information
Table 3.1
To Next Page
Loading...
