MUA-SVX003B-EN
25
Electrical Connections
WWAARRNNIINNGG
HHaazzaarrddoouuss VVoollttaaggee!!
FFaaiilluurree ttoo ddiissccoonnnneecctt ppoowweerr bbeeffoorree sseerrvviicciinngg ccoouulldd rreessuulltt iinn ddeeaatthh oorr sseerriioouuss iinnjjuurryy..
DDiissccoonnnneecctt aallll eelleeccttrriicc ppoowweerr,, iinncclluuddiinngg rreemmoottee ddiissccoonnnneeccttss bbeeffoorree sseerrvviicciinngg.. FFoollllooww
pprrooppeerr lloocckkoouutt//ttaaggoouutt pprroocceedduurreess ttoo eennssuurree tthhee ppoowweerr ccaann nnoott bbee iinnaaddvveerrtteennttllyy
eenneerrggiizzeedd.. VVeerriiffyy tthhaatt nnoo ppoowweerr iiss pprreesseenntt wwiitthh aa vvoollttmmeetteerr..
All electrical connections must conform to the latest edition of ANSI/NFPA No. 70 National
Electrical Code and applicable local codes. In Canada, to the Canadian Electrical Code, Part I CSA
Standard C22.1.
The rooftop packaged unit is wired at the factory and ready to be connected. Actual unit wiring
will differ according to the options chosen. Each unit is shipped with its own wiring diagram;
refer to this wiring diagram for all electrical connections to the unit.
All electrical connections, line voltage and thermostat, are made in the Electrical Cabinet (See
Figure 10, p. 26). Line voltage connections are made at the High Voltage Terminal Block.
Thermostat connections are made at the Main Connection Board (See Figure 10, p. 26).
WWAARRNNIINNGG
RRiisskk ooff EElleeccttrrooccuuttiioonn!!
FFaaiilluurree ttoo ffoollllooww iinnssttrruuccttiioonnss bbeellooww ccoouulldd rreessuulltt iinn ddeeaatthh oorr sseerriioouuss iinnjjuurryy..
DDOO NNOOTT uussee aannyy ttoooollss ((ii..ee.. ssccrreewwddrriivveerr,, pplliieerrss,, eettcc..)) aaccrroossss tthhee tteerrmmiinnaallss ttoo cchheecckk ffoorr
ppoowweerr.. YYoouu MMUUSSTT uussee aa vvoollttmmeetteerr..
Figure 9. Standard Blower Cabinet, Single Duct Furnace with Supply Plenum & Various
Options Shown
IInnssttaallllaattiioonn