Trane IntelliPak CGAF Series - GBAS 0-10 VDC Module I;O Assignments

30
System Programming SETUP
1. Press the NEXT key to display Generic BAS Binary Output
2 Definition screen.
2. Press the + or - key until the proper value is displayed.
Used on Units:
With GBAS 0-5VDC Module
3. Press the ENTER key to confirm this choice.
Possible Values:
Output is Not Assi
g
ned
4. Press the NEXT key to display Generic BAS Binary Output Indicate Selected Dia
g
Alarms
3 screen. Indicate Unit at Max Capacity
5. Press the + or - key until the proper value is displayed. Indicate any comp is runnin
g
6. Press the ENTER key to confirm each choice.
7. Repeat steps 1 - 4 to display Generic BAS Binary Output
screens 3, 4 & 5.
8. Press the NEXT key to advance to the followin
g
screen.
1. Pressin
g
the NEXT key will display the be
g
innin
g
of
the Submenu.
2. Press the NEXT key a
g
ain to advance to the followin
g
screen.
This screen is displayed when GBAS 0-10 VDC Module is installed
1.To view the factory preset or to modified the factory presets
to meet specific application requirements, press the
ENTER key. If no adjustments are required, press the NEXT
key to advance to the "CGM Alarm Output Diagnostic
Assignments"
2. Press the + or - key until the proper value is displayed.
Used on Units:
With GBAS 0-10VDC Module
3. Press the ENTER key to confirm this choice.
Possible Values:
Not Assi
g
ned
4. Press the NEXT key to display Generic BAS Analo
g
Input Leavin
g
Solution Setpoint
2 screen. Ice Build Terminate Setpoint
5. Press the + or - key until the proper value is displayed. Hot Start Load Limit Setpoint
6. Press the ENTER key to confirm each choice. Capacity Limit Setpoint
7. Repeat steps 1 - 4 to display Generic BAS Analo
g
Input
screens 2, 3 & 4.
8. Press the NEXT key to advance to the following screen.
1. Press the + or - key until the proper value is displayed.
Used on Units:
With GBAS 0-10VDC Module
2. Press the ENTER key to confirm this choice.
Possible Values:
Output is Not Assi
g
ned
3. Press the NEXT key until the followin
g
screen is displayed. Indicate Selected Dia
g
Alarms
Indicate Unit at Max Capacity
The followin
g
screen will display if "Indicate selected dia
g
Indicate any comp is runnin
g
alarms" is assi
g
ned.
1.To view the factory preset or to modified the factory presets
to meet specific application requirements, press the
ENTER key to advance to the followin
g
screens. If no
adjustments are required, press the NEXT key to advance to
the GBAS Analo
g
Output Assi
g
nment screen.
End of Submenu (NEXT) to Re-enter SETUP
GBAS 0-10VDC Module I/O Assignments
Press ENTER to Review or Adjust
GBAS (0-10VDC) Analog Input 1 Assignment
NOT ASSIGNED
GBAS (0-10VDC) Binary Output Definition
OUTPUT IS NOT ASSIGNED
GBAS (0-5VDC) Binary Output 2 Definition
OUTPUT IS NOT ASSIGNED
GBAS (0-10VDC) Output Alarm Assignments
Press ENTER to Review or Ad
j
ust