BAS-SVX090B-EN
15
2. Gently push on lower half of device in the direction of the arrow until the release clip locks into place.
To remove or reposition the controller:
1. Disconnect all connectors.
2. Insert a screwdriver blade into the slotted release clip (shown below) and gently pry upward to
disengage the clip.
3. While holding tension on the clip, lift the controller upward to free it from the DIN rail.
4. Reposition the controller by sliding it sideways or by removing it completely and reattaching it.
5. Gently push on lower half of device in the direction of the arrow until the release clip locks into place.
Slotted release clip
shown from back side.
Pry upward.
Mounting the Symbio 500
To Next Page
Loading...
