Trane TR170 - Bus Bar; RFI Filter

8.4.5 Bus Bar
1. Unplug and remove the red/black cable.
2. Remove the black plastic cover.
3. Remove 6 screws (T20) and 2 screws (T30) from
the support bracket.
4. Remove the bus bar assembly.
Reinstall in the reverse order.
1Bus bar
Illustration 8.28 Bus Bar
8.4.6 RFI Filter
1. Unplug the 3 lter cables from the thyristors
using a hex 8 key.
2. Loosen the 3 cables from the cable connector
using a hex 5 key.
3. Remove 3 screws (T20) from the support bracket.
4. Remove support bracket.
5. Remove 4 screws (T20) from the RFI lter.
6. Remove the entire assembly.
Reinstall in the reverse order.
1RFI lter
Table 8.1
Illustration 8.29 RFI Filter
I-Frame Size Disassembly an... TR150 and TR170 Service Manual
BAS-SVM04B-EN 02/2017 All rights reserved. 89
8
8