8.4.7 Relay Transducer Card
1. Remove 2 screws (T20) from each of the 2 cable
connectors.
2. Remove the cable connector.
3. Remove 3 screws (T20) from the support bracket.
4. Loosen the 3 cables (T30) from the relay
transducer card.
5. Unplug all other cables from the relay transducer
card.
6. Remove the 3 screws (T20).
7. Remove the relay transducer card.
Reinstall in the reverse order.
1 Relay transducer card
Illustration 8.30 Relay Transducer Card
8.4.8 Terminal Plate
1. Remove 4 screws (T20) on the cover plate.
2. Remove the complete terminal plate including
cable connector.
Reinstall in the reverse order.
1Terminal plate
Illustration 8.31 Terminal Plate
I-Frame Size Disassembly an...
90 02/2017 All rights reserved. BAS-SVM04B-EN
8
To Next Page
Loading...
