1.1.1 Display Settings
Description Units
1. Date Format Enum
2. Date (4)
3. Time Format (12-hour, 24-hour), 12-hour Enum
4. Time of Day (4)
5. Keypad/Display Lockout (Enable, Disable), Disable (3) Enum
6. Display Units (SI, English), SI Enum
7. Pressure Units (Absolute, Gauge), Gauge Enum
8. Language (5) Enum
(1) Language choices are dependent on what the Service Tool has setup in the Main Processor. Get Radio Button
names from Main Processor setups. Language selections will include English and qty 2 alternate as loaded by
TechView.
(2) Temperatures will be adjustable to 0.1 deg F or C. The Main Processor will provide the minimum and
maximum allowable value.
(3) Enables a DynaView Lockout screen. All other screens timeout in 30 minutes to this screen. The DynaView
Lockout Screen will have 0-9 keypad to permit the user to re-enter the other DynaView screens with a fixed
password. See below for further details.
(4) The Date and Time setup screen formats deviate slightly from the standard screens defined above. See the
alternate screen layouts below.
(5) Language shall always be the last setting listed on the Control Settings menu (which will also always be the
last item listed on the Settings menu list). This will allow a user to easily find language selection if looking at
an unrecognizable language.
(6) The pump on mode terminates after 60 minutes.
(7) These items cannot be set to "Manual" from the DynaView - The manual buttons on the Manual Control
submode screen are hidden unless the particular item has been set to manual from the Service Tool - The
auto button shall be operational to change the mode back to auto. The subscreen shall also display a note:
"Manual not available from Front Panel - See Service Tool for Manual Mode"
(8) Buttons are displayed on this Manual Control submode screens depending on the pumpdown status:, when in
"pumpdown", the abort button is shown, when "not available", no buttons shown, when "continue",
pumpdown button is shown.
DynaView Interface
25RLC-SVU05A-E4
Resolution or (Enumerations),
Default
("mmm dd, yyy", "dd-mmm-yyyy"),
"mmm dd, yyy"
(English, Selection 2, Selection 3),
English (1)
To Next Page
Loading...
