DynaView Interface
RLC-SVU05A-E426
Auto, Stop/Immediate
Stop
The AUTO and STOP keys are radio
buttons within the persistent key
display area. The selected key will
be black.
The chiller will stop when the STOP
key is touched, entering the Run
Unload mode. An informational
screen will be displayed for
5 seconds indicating that a second
depression of an "Immediate Stop"
key during this time period will
result in an immediate/panic stop.
Pressing the "Immediate Stop" key
while the panic stop screen is
displayed, will cause the unit to
stop immediately, skipping
operational pumpdown.
Touching the Auto key will arm the
chiller for active cooling if no
diagnostic is present. A separate
action must be taken to clear active
diagnostics.
The AUTO and STOP keys take
precedence over the ENTER and
CANCEL keys. While a setting is
being changed, AUTO and STOP
keys are recognized even if ENTER
or CANCEL has not been pressed.
When an active diagnostic is
present, an ALARMS key will be
added to the persistent display area.
This key is used to alert the
operator that a diagnostic exists, or
to provide navigation to a
diagnostic display screen.
Figure 11
To Next Page
Loading...
