What to do if my Trane Air Conditioner motor fails to start?
If your Trane Air Conditioner motor fails to start, it could be due to several reasons. If the current supply is improper, contact your power company for adjustments. If there is a mechanical failure, check that the fan rotates freely. If there is low line voltage, check across the AC line and correct the voltage if possible.
What to do if my Trane Air Conditioner has missing filters?
If your Trane Air Conditioner is missing filters, replace them.
What to do if my Trane Air Conditioner motor overheats?
If your Trane Air Conditioner's motor overheats, several factors could be responsible. Begin by checking the voltage at the motor terminals and correct any voltage loss if possible. Ensure that the line wiring to the motor is adequately sized, replacing it with larger wiring if necessary. Reduce the motor load or consider replacing it with a larger motor if it's overloaded. Inspect the motor fan for obstructions, removing the fan cover to clean the fan if it's clogged with dirt. Tighten any loose motor mounting bolts. Replace rigid coupling connections with flexible connections. Finally, check for and remove any interference causing the fan to rub on the fan cover.
What to do if my Trane Air Conditioner has low water coil capacity?
If your Trane Air Conditioner has low water coil capacity, start by inspecting the water pumps and valves for proper operation and check the lines for any obstructions. Also, adjust the chiller or boiler to ensure the proper water temperature. Clean the fin surface.
What to do if my Trane Air Conditioner has excessive vibration?
If your Trane Air Conditioner is experiencing excessive vibration, check the fan alignment by aligning and retightening the bearing set screws. Also, ensure that all shipping spacers and/or bolts have been removed.
How to fix wet interior of Trane Air Conditioner?
To address a wet interior in your Trane Air Conditioner, consider these solutions: reduce the fan speed if the coil face velocity is too high. Repair any leaks if the drain pan is leaking or overflowing. Insulate the surfaces if condensation is forming on them.
How to fix a blown fuse in my Trane Air Conditioner?
If your Trane Air Conditioner has a blown fuse or an open circuit breaker, replace the fuse or reset the circuit breaker.
What to do if my Trane Air Conditioner motor runs and then dies down?
If your Trane Air Conditioner motor runs and then dies down, check for loose connections. Also, determine the adequacy of the main power supply.
What to do if my Trane Air Conditioner has an overload trip?
If your Trane Air Conditioner experiences an overload trip, check and reset the overload.
What to do if my Trane Air Conditioner has improper wiring or connections?
If your Trane Air Conditioner has improper wiring or connections, check the wiring with the diagram supplied on the unit.
General| Type | Fan-Coil |
|---|---|
| Heating Capacity | Varies by model |
| Voltage | 208/230V, 277V |
| Control Options | Thermostat |
| Airflow | Varies by model |
| Sound Level | Varies by model |
| Cabinet | Galvanized steel with powder coat finish |
| Insulation | Fiberglass |
| Filter | throwaway |
To Next Page
