BAS-SVX10C-EN 23
Operation
This section describes sensor operations.
Changing Temperature Settings
To change temperature settings:
• For sensors with temperature setpoint thumb wheels (located on top of the sensor), rotate the
thumb wheel to the desired temperature setting.
Note: If you need to change or replace a thumb wheel, see “Changing the Setpoint Thumb
Wheel (optional),” p. 21.
• For sensors with dual temperature sliders (located on the right front of the sensor): Slide the
blue (cool) slider to the desired maximum temperature setting. Slide the red (heat) slider to the
desired minimum temperature setting.
• For the display sensor, see “Changing Temperature Settings,” p. 27 and “Changing Heating and
Cooling Temperature Settings (dual setpoint systems only),” p. 27.
Changing System Settings
To change system settings:
• For sensors with system thumb wheels (located on the upper left side), rotate the thumb wheel
to the desired setting.
• For the display sensor, see “Changing System Settings,” p. 28.
Notes:
• Not all sensor models have all system setting options.
• The effect of setting changes are dependent on the unit controller. See specific unit controller
manual for details.
Changing Fan Settings
To change fan settings:
• For sensors with fan thumb wheels (located on the lower left side), rotate the thumb wheel to
the desired setting.
• For the display sensor, see “Changing Fan Settings,” p. 28.
Notes:
• Not all sensor models have all fan setting options.
• The effect of setting changes are dependent on the unit controller. See specific unit controller
manual for details.
To Next Page
Loading...
Need help?
General
