Cooling setpoint Occupied
mode
Heating setpoint Occupied
mode
Cooling setpoint Unoccupied
mode
Cooling
set? Y/N
No next
Yes down
Heating
set? Y/N
No next
Yes down
Unocc CL
set? Y/N
No next
Yes down
Use ▲▼ keys to set
value, Yes key to confirm
Cooling
70.0°F
Use ▲▼ To set
value
Heating
68.0°F
Use ▲▼ To set
value
Unocc CL
80.0°F
Use ▲▼ To set
value
Heating setpoint Unoccupied
mode
°F or °C display setting
Unocc
HT set? Y/N
No next
Yes down
°F or °C
set? Y/N
No next
Yes down
Use ▲▼ keys to set value, Yes key to confirm
Unocc HT 60.0°F
Use ▲▼
To set
value
Units °F
Use ▲▼ To set
value
18 BAS-SVU10C-EN
The User Menu Sequence
Temporary Setpoint Changes
(▲) (▼)
Temporary setpoints can be modified through the Up arrow key and the Down arrow
keys.
(Heating or Cooling) You are prompted with the present mode of the thermostat and its setpoint.
(▲) The Up arrow key will increment the setpoint by 0.5 degree (°F or °C).
(▼) The Down arrow key will decrement the setpoint by 0.5 degree (°F or °C).
Press the Yes key to accept the new setpoint.
Notes:
• Local changes to
the heating or cooling setpoints made directly using the up or down arrow are
temporary.
• Local changes remain effective for the duration specified by ToccTime.
• Setpoints revert back to their default value after internal timer ToccTime expires.
• If a permanent change to the setpoints is req
uired, use the Temperat set? menu.
System mode
setting
This menu is accessed to set system mode operation
Use ▲▼ keys to s
et value, Yes key to confirm.
Sys mode Y/N
Sys mode auto
Automatic mode
Automatic changeover mode between heating and cooling operation
Sys mode cooling
Cooling mode
Cooling operation mode only
Sys mode heating
Heating mode
Heating operation mode only
Sys mode emergency
Emergency heat mode (
hea
t pump models only)
Forced auxiliary heat operation mode only
Sys mode off
Off mode Normal cooling o
r heating operation disabled
If enabled in installer parameters, only the automatic heati
ng frost protection at 50°F
(10°C) is enabled
To Next Page
Loading...
