TransCore AP4119 - Chapter 1 Programmer Basics; Equipment, ESD Protection, and Host Connection

Chapter 1 Programmer Basics
TransCore Proprietary
1–7
Chapter 1 Programmer Basics
This chapter lists the factory-supplied and optional equipment for the AP4119
programmer, and describes how to prevent electrostatic discharge (ESD) damage
to tags, connect to a host device, and install the optional tag programming software
to the host computer.
Factory Supplied and Optional Equipment
The programmer is shipped with the items listed. Make sure all of the items are included when unpacking
the order:
• AP4119 Rail Tag Programmer
• Programmer Accessory Kit P/N 19143-01 (Table 1)
Table 1 Accessory Kit P/N 19143-01
Accessory Kit Item
Qty
(ea)
Power transformer and cable to convert AC voltage to 24 VDC 1
Power cord 1
Programmer-to-PC RS–232 connecting cable 1
Programmer-to-PC USB Type A Cable 1
Static-suppression wrist strap with cord 1
TransCore USB flash drive with AP4119 Tag Programmer Host Software 1
AP4119 Programmer User Guide 1
If any of the items in Table 1 are missing from the order, contact the TransCore distributor.
Note: The AT5549 End-of-Train Tag requires a Programmer Adapter (P/N 20-4119-001) in order to
seat the AT5549 tag during programming. This adapter is an optional purchase item.
The AP4119 requires a host computer system such as a PC or communications terminal for operation.
TransCore does not supply this equipment for the AP4119 Rail Tag Programmer.