T9
-19-
MAINTENANCE AND CARE
Cleaning
n Keep the machine clean at all times. Some
maintenance products and solvents may
damage the plastic parts, these include
products containing Benzene, Trichloroethyle
Chloride and Ammonia.
n Never use any caustic agents to clean the
plastic parts.
Changing Brushes
n Isolate machine from the power supply.
n Plunge the machine to its lowest point and
lock the plunge lever (1).
n Gently undo the plunge depth knob and rod
assembly (2), and remove.
n Undo the four screws (3), and take off the
cover (4).
n Pull back the spring (5) and unclip the wire
(6).
n Remove the carbon brush (7) and replace it.
n Refit the spring (5) and re-connect the wire
(6).
n Refit the cover (4) ensuring the depth stop
dial (8) is correctly positioned.
n Refit the plunge depth knob and rod assembly
(2) carefully.
n Always use original T9 spare parts.
Lubrication
n The bearings of the machine need no
lubrication, as they are sealed. The two
plunge columns on the routing base should
be slightly oiled from time to time.
n Keep the cooling vents on the motor housing
clean and unobstructed at all times. Blow out
any dust and dirt at regular intervals.
n Visually check the carbon brushes. In the
event of excessive sparking, they may need
changing.
n After about 40 operating hours inspection by
a authorised Trend service agent is
recommended.
RECYCLING
Machine, accessories and packaging should be
sorted for environmentally friendly recycling.
GUARANTEE
The machine carries a manufacturers guarantee
in accordance with the conditions on the
enclosed guarantee card.
For the location of your nearest T
rend Service
The carbon brushes will need replacing when
they become worn to a certain limit. This will
become evident when the router won’t start up
again after being switched off.
Ensure machine is isolated
from power supply.
It is advisable to have the brushes
replaced by an authorised Trend
service agent. The router will also be
given a thorough inspection.
To Next Page
Loading...
