Ignore: This parameter indicates that the setting in the All row do not apply to the
Loopback Detection Status field. In other words, each port is set individually.
• Enabled: This selection enables the Loopback Detection feature for each port.
This state must be enabled along with the Status field at the top of the page
before this feature can be active on the selected port.
• Disabled: This selection disables the Loopback Detection feature on the
selected port.
• Note: In the All row when you select Enable or Disable instead of Ignore, the
selection applies to all of the Switch ports.
Next to each entry modified, under the Action column, click Apply to save the changes.
4. At the bottom of the left-hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Static Unicast
Add static unicast entries to the switch
Network > Static Unicast
In this section, you can add static unicast entries to the switch configuration.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Network and click on Static Unicast.
3. Review the settings.
• 802.1Q VLAN – Enter the VLAN ID where the MAC address will reside.
Note: By default, all switch ports are part of the default VLAN, VLAN ID 1.
• MAC Address – Enter the MAC address of the device to add.
• Port Member – Select the port where the MAC address will reside.
Click Apply to add the Static Unicast entry to the list.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all the entries in the list. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
To Next Page
Loading...
