Set LLDP Port State
For each port, click the State drop-down list and choose from the following options.
• Disabled: Indicates LLDP is disabled on the port. The port cannot receive or
transmit LLDP data packets.
• RxTx: Indicates LLDP is enabled on the port. The port can receive and transmit
LLDP data packets.
• RxOnly: Indicates LLDP is enabled on the port. The port can receive LLDP data
packets.
• TxOnly: Indicates LLDP is enabled on the port. The port can transmit LLDP data
packets.
Note: You can select the row labeled ALL to apply settings to all ports.
Click Apply to save the settings.
4. At the bottom of the left-hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Basic TLVs Settings
Network > LLDP > Basic TLVs Settings
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Network, click on LLDP, and click on Basic TLVs Settings.
3. Configure the basic TLVs settings. Click Apply to save.
4. At the bottom of the left-hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Dot1 TLVs Settings
Network > LLDP > Dot1 TLVs Settings
To Next Page
Loading...
