1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Network, click on LLDP, and click on Neighbor.
3. View the LLDP neighbor information.
• Entity: This parameter is a number assigned to the reporting neighbors in the
order that the LLDP information is received from them.
• Port: This parameter specifies the switch port number where the LLDP
information was received.
• Chassis ID Subtype: This parameter describes the Chassis ID subtype of the
neighboring network device which is reporting the LLDP information.
• Chassis ID: This parameter is the neighboring device’s chassis ID.
• Port ID Subtype: This parameter describes the Port ID subtype of the
neighboring network device’s port that is connected directly to the switch port.
• Port ID: This parameter specifies the neighboring network device’s port
number from which the LLDP information was transmitted.
• Port Description: This parameter describes the neighboring network device’s
port.
• Show Detail: If you click on this button, a detailed report of the neighboring
network device will be displayed.
If the entries span multiple pages, you can navigate page number in the Page field and
click Go or you can click First, Previous, Next, and Last Page to navigate the pages.
MAC VLAN
MAC VLAN
Network > MAC VLAN
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Network and click on MAC VLAN.
3. Configure the MAC VLAN. Click Add to save.
• MAC Address – Enter the MAC Address to add to the VLAN
• Description – Enter a Description.
• VLAN ID – Assign a VLAN ID
4. At the bottom of the left-hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
To Next Page
Loading...
