TRENDnet TI-PG541i - Page 71

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Industrial Managed Switch Series
68
The default Loop Detection Destination MAC is 00:0b:04:AA:AA:AB
The default Port Loop-Detection state is disabled for all ports.
The default Port Loop-Detection status is unblocked for all ports.
The loop detection on the Switch is disabled.
Loop Detection Destination MAC=00:0b:04:aa:aa:ab
Recovery Recovery
Port State Status State Time Port State Status State Time
---- -------- ------- -------- ---- ---- -------- ------- -------- ----
1 Disabled Normal Enabled 1 2 Disabled Normal Enabled 1
3 Disabled Normal Enabled 1 4 Disabled Normal Enabled 1
5 Disabled Normal Enabled 1 6 Disabled Normal Enabled 1
7 Disabled Normal Enabled 1 8 Disabled Normal Enabled 1
9 Disabled Normal Enabled 1 10 Disabled Normal Enabled 1
11 Disabled Normal Enabled 1 12 Disabled Normal Enabled 1
13 Disabled Normal Enabled 1 14 Disabled Normal Enabled 1
15 Disabled Normal Enabled 1 16 Disabled Normal Enabled 1
CLI Configuration
Node
Command
Description
enable
show loop-detection
This command displays the current
loop detection configurations.
configure
loop-detection (disable | enable)
This command disables / enables
the loop detection on the switch.
configure
loop-detection address
MACADDR
This command configures the
destination MAC for the loop
detection special packets.
configure
no loop-detection address
This command configures the
destination MAC to default
(00:0b:04:AA:AA:AB).
interface
loop-detection (disable | enable)
This command disables / enables
the loop detection on the port.
interface
no shutdown
This command enables the port. It
can unblock port blocked by loop
detection.
interface
loop-detection recovery (disable
| enable)
This command enables / disables
the recovery function on the port.
interface
loop-detection recovery time
VALUE
This command configures the
recovery period time.
configure
interface range
gigabitethernet1/0/ PORTLISTS
This command enters the interface
configure node.
if-range
loop-detection (disable | enable)
This command disables / enables
the loop detection on the ports.
if-range
loop-detection recovery (disable
| enable)
This command enables / disables
the recovery function on the port.
if-range
loop-detection recovery time
VALUE
This command configures the
recovery period time.
Example:
[DEVICE_NAME](config)#loop-detection enable
[DEVICE_NAME](config)#interface 1/0/1
[DEVICE_NAME](config-if)#loop-detection enable