10-6
CLASS C MOTORHOME
10.2.3 GENERATOR OPERATION
1. Controls:
The generator switch is located in the kitchen
area.
CAUTION
Overloading the generator for
long periods of time can cause
high temperatures that could
result in damage to the genera-
tor windings. Keep electrical
loads within the wattage ratings
specified in your manual.
3. Stopping:
a. Turn off lights and all appliances before
shutting off engine. Let the engine run at
no-load for a few minutes to allow the
engine to cool down.
b. Press the generator start button and hold
until engine comes to a complete stop.
Fig. 10-8 GENERATOR CONTROL
IMPORTANT
The generator starter does not
draw current from the engine
batteries so the ignition does not
have to be on.
2. Starting:
a. See Generator Manufacturer's Manual
for specific instructions.
b. Disconnect all electrical loads. (Turn
off all lights, appliances, equipment,
etc.).
c. Press generator start button, hold until
engine is running, then release.
d. Allow the engine on the generator to
start and run smoothly before operating
electrical appliances.
e. Be familiar with the output capacity
and capability of your generator.
f. Be careful not to overload the genera-
tor. See your manual for information
on this.
To Next Page
Loading...
