Triple E EMPRESS SERIES - System Monitor

4-26
EMPRESS
4.20 SYSTEM MONITOR
A system monitor is locatedat the Electric Control
Center in the hallway.
1.
Status LED's:
Five LED's are used to indicate the status of
the tanks and battery. The tank scale registers
EMPTY, 1/4, 1/2, 3/4 or FULL.
The battery
charge condition registers
POOR, FAIR
and
GOOD
. Read the appropriate scale when the
battery or tank switches are depressed.
2.
System Switches:
Each system is equipped with a switch to acti-
vate its own monitoring system. Depress and
hold the switch. The system condition will be
shown by the LEDs above.
a.
Coach Battery
b.
Fresh Water Tank
c.
Grey Water Tank
d.
Black Water Tank
e.
LP Gas Tank
SYSTEM MONITOR
3.
SYSTEM MONITOR
3.
SYSTEM MONITOR
Water Pump Master:
SYSTEM MONITOR
Water Pump Master:
SYSTEM MONITOR
This rocker switch controls the power to the
water pump. Depress the top of the switch to
turn the power to the pump on. A red light in
the switch will come on when the power is on.
Depress the bottom of the switch to turn off and
the light will go off. When the power is on, the
remote momentary switches can be used to
turn the pump on and off . See 4.15.3 for more
information.
a
b c
d
e
4.
Generator:
This 3 position rocker switch controls the
power to the auxiliary generator.
a.
Starting:
Depress the top portion of the switch
against the spring load to engage the
starter and start the engine. Release the
switch when the engine starts and it will
return to the run position.
b.
Stopping:
Depress the bottom portion of the switch
and hold until the generator stops. Re-
lease the switch.
5.
Water Heater:
This rocker switch controls the electrical power
to the water heater igniter. Depress the top
part of the switch and the water heater will
ignite. The red light in the switch will go off
when the burner ignites or it will remain on if
the burner fails to ignite.