General Information
36
High Beam Light
When the ignition is switched
ON and the headlight dip switch is set to
HIGH BEAM, the high beam warning
light will illuminate.
Direction Indicators
When the direction indicator
switch is turned to the left or right, the
direction indicator warning light will
flash on and off at the same speed as
the direction indicators.
Daytime Running Lights (DRL) (if
fitted)
When the ignition is switched
ON and the daytime running lights
switch is set to Daytime Running Lights,
the daytime running lights warning light
will illuminate.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page36.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the Daytime Running
Lights when dark, in tunnels or where
poor ambient light is apparent may
reduce the riders vision or dazzle
other road users.
Dazzling other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control
and an accident.
Note
During daylight hours the Daytime
Running Lights (DRL) improve the
motorcycles visibility to other road
users.
Low beam headlights must be used in
any other conditions unless the road
conditions allow for high beam
headlights to be used.
Warning and Information Messages
Note
It is possible for multiple warning and
information messages to be displayed
when a fault occurs. Where this is the
case, warning messages will take
priority over information messages and
the warning symbol will be shown on the
display.
The number of currently active warning
messages is shown in the information
tray.
To Next Page
Loading...
Need help?
General
