EasyManuals Logo

Triumph Speed Triple R Handbook

Triumph Speed Triple R
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #126 background imageLoading...
Page #126 background image
126
Storage
Preparation after Storage
Install the battery (if removed) (see page 111 ).
If the motorcycle has been stored for more
than four months, change the engine oil (see
page 79).
Check all the points listed in the Daily Safety
Checks section.
Before starting the engine, remove the spark
plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter motor several
times until the oil pressure light goes out.
Replace the spark plugs, tightening to
12 N m , and start the engine.
Check and if necessary correct the tyre
pressures (see page 10 6 ).
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.

Table of Contents

Other manuals for Triumph Speed Triple R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Speed Triple R and is the answer not in the manual?

Triumph Speed Triple R Specifications

General IconGeneral
Engine Capacity1050 cc
Transmission6-speed
Seat Height825 mm
Fuel SystemMultipoint sequential electronic fuel injection
Engine TypeLiquid-cooled, 12-valve, inline 3-cylinder
Power148 hp (110 kW) @ 10, 500 rpm
Torque117 Nm at 7, 150 rpm
Front SuspensionÖhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear SuspensionÖhlins TTX36 monoshock, fully adjustable
Front BrakesTwin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity15.5 litres

Related product manuals