Triumph Speed Triple R Handbook

58
How to Ride the Motorcycle
Changing Gears
1. Gear change pedal
Close the throttle while pulling in the
clutch lever. Change into the next
higher or lower gear. Open the throttle
part way, while releasing the clutch
lever. Always use the clutch when
changing gear.
Note:
• The gear change mechanism is the
'positive stop' type. This means
that, for each movement of the
gear change pedal, you can only
select each gear, one after the
other, in ascending or descending
order.
Warning
Take care to avoid opening the throttle too
far or too fast in any of the lower gears as
this can lead to the front wheel lifting from
the ground (pulling a 'wheelie') and to the
rear tyre breaking traction (wheel spin).
Always open the throttle cautiously,
particularly if you are unfamiliar with the
motorcycle, as a 'wheelie' or loss of traction
will cause loss of motorcycle control and an
accident.
1
cgez
Warning
Do not change to a lower gear at speeds
that will cause excessive engine rpm
(r/min). This can lock the rear wheel
causing loss of control and an accident.
Engine damage may also be caused.
Changing down should be done such that
low engine speeds will be ensured.

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres