Triumph Speed Triple R Handbook

96
Maintenance and Adjustment
Brake Light Switches
The brake light is activated independently by
either the front or rear brake. If, with the
ignition in the ON position, the brake light
does not work when the front brake lever is
pulled or the rear brake pedal is pressed,
have your authorised Triumph dealer
investigate and rectify the fault.
Steering/Wheel Bearings
Steering Inspection
Lubricate and inspect the condition of the
headstock (steering) bearings in accordance
with scheduled maintenance requirements.
Note:
• Always inspect the wheel bearings
at the same time as the steering
bearings.
Warning
Riding the motorcycle with defective brake
lights is illegal and dangerous.
An accident causing injury to the rider and
other road users may result from use of a
motorcycle with defective brake lights.
Warning
To prevent risk of injury from the
motorcycle falling during the inspection,
ensure that the motorcycle is stabilised and
secured on a suitable support. Do not
exert extreme force against each wheel or
rock each wheel vigorously as this may
cause the motorcycle to become unstable
and cause injury by falling from its support.
Ensure that the position of the support
block will not cause damage to the sump.

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres