Triumph Speed Triple R Handbook

31
General Information
Data Recording Mode
1. L a p d i s p l a y
2. Stop watch icon
3. Lap time
Note:
• The data recording mode and the
data retrieval mode will only
operate when the lap timer (lap) is
turned on.
To select the data recording mode, turn the
ignition to the ON position.
Press and release button 'A' until Lap is visible
in the screen then press button 'B'. L01 and a
stop watch icon will be visible in the
speedometer display, and the lap timer will
be visible in the display screen.
Pressing the starter button (with the engine
running only) will start the lap timer. The
display will show the lap time in minutes,
seconds and hundredths of a second, and the
stop watch icon is on.
New Lap Recording
1. Starter button
At the end of the lap, pressing the starter
button again will register the start of a new
lap. The display will show the last lap time for
5 seconds, then the new lap number for
5 seconds. After this time, the speedometer
display will show the current lap number and
the display screen will show the current lap
time.
1
cfiv_11
3
2
ccmh_1
1

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres