23
General Information
Trip Meter Reset
To reset either of the trip meters, select and
display the trip meter to be zeroed then press
button 'B' for 2 seconds. After 2 seconds, the
trip meter on display will reset to zero.
Note:
• When a trip meter is reset to zero,
the journey time, average fuel
consumption and average speed
will also be set to zero for that trip
meter.
To exit the trip meter, press and release
button 'A' until the desired display is visible.
Odometer
When the ignition is switched on, the
odometer will be displayed for 3 seconds
then the last selected trip meter will be
shown.
The odometer shows the total distance that
the motorcycle has travelled.
To access the odometer, with the motorcycle
stationary and in neutral press and release
button 'A' until set up is visible in the display
screen then press button 'B'. Press and
release button 'A' until odometer is visible.
To exit odometer, press and release
button 'A' until r
Eturn is visible then press
button 'B'. Trip 1 will be visible in the display
screen.
Clock Adjustment
To reset the clock, with the motorcycle
stationary and in neutral turn the ignition to
the ON position. Press and release button 'A'
until set up is visible in the display screen.
Press button 'B' and t-SEt will be visible.
Press button 'B' again and either 24 Hr or
12 Hr clock will be shown. Press button 'A' to
select the desired clock display and then
press button 'B'. The hour display will start to
flash and the word Hour is visible in the
display screen.
To reset the hour display, ensure that the
hour display is still flashing and the word
Hour is visible. Press button 'A' to change the
setting. Each individual button press will
change the setting by one digit. If the button
is held, the display will continuously scroll
through in single digit increments.
When the correct hour display is shown,
press button 'B'. The minutes display will
begin to flash and the word Min is visible in
the display screen. The minutes display is
adjusted in the same way as for the hours.