Triumph T120 - Front Suspension Preload Adjustment - Thruxton R Only; Front Suspension Rebound and Compression Damping Adjustment - Thruxton R Only

Maintenance
101
Front Suspension Preload
Adjustment - Thruxton R Only
ciys
1
1. Front suspension preload adjuster
The preload adjuster is located at the
bottom of the front suspension unit.
To change the preload, rotate the
adjuster clockwise to increase, or
anticlockwise to decrease using the
Allen key located in the right hand side
panel.
Always count the number of turns from
the fully clockwise position noting that
the first turn is counted as zero.
Note:
• The motorcycle is delivered from
the factory with the preload
adjuster set at the Solo Riding
settings, as shown in the relevant
suspension chart (see
page100
).
Front Suspension Rebound and
Compression Damping Adjustment -
Thruxton R Only
ciyt
Front suspension rebound and
compression damping adjusters
The rebound and compression damping
adjusters are located at the top of each
fork.
To change the rebound damping setting,
rotate the TEN slotted adjuster
clockwise to increase, or anticlockwise
to decrease.
To change the compression damping
setting, rotate the COM slotted adjuster
clockwise to increase, or anticlockwise
to decrease.
Always count the number of
anticlockwise turns from the fully
clockwise position.
Note:
• The motorcycle is delivered from
the factory with the rebound and
compression damping adjusters set
at the Solo Riding settings, as
shown in the relevant suspension
chart (see
page100
).