Triumph T120 - Front Brake Fluid Level Inspection and Adjustment

Maintenance
93
Warning
Continued
Always use new brake fluid from a
sealed container and never use fluid
from an unsealed container or from
one which has been previously opened.
Do not mix different brands or grades
of brake fluid.
Check for fluid leakage around brake
fittings, seals and joints and also check
the brake hoses for splits, deterioration
and damage.
Always rectify any faults before riding.
Failure to observe and act upon any of
these items may cause a dangerous
riding condition leading to loss of
control and an accident.
Warning
If the ABS is not functioning, the brake
system will continue to function as a
standard non-ABS braking system. In
this situation, braking too hard will
cause the wheels to lock resulting in
loss of control and an accident.
Reduce speed and do not continue to
ride for longer than is necessary with
the indicator light illuminated. Contact
an authorized Triumph dealer as soon
as possible to have the fault checked
and rectified.
Note:
• A special tool is required to bleed
the ABS braking system. Contact
your authorized Triumph dealer
when the brake fluid needs
replacing or the hydraulic system
requires maintenance.
Front Brake Fluid Level Inspection
and Adjustment
Inspect and adjust the brake fluid level
as described below:
Street Twin
jajc
3
1
2
1. Upper level line, front brake
2. Lower level line, front brake
3. Safety clip
The brake fluid level must be kept
between the upper and lower level lines
(reservoir held horizontal).
To adjust the brake fluid level, remove
the safety clip.
Remove the reservoir cap and
diaphragm seal.
Fill the reservoir to the upper level line
using new DOT 4 fluid from a sealed
container.
Refit the reservoir cap ensuring that
the diaphragm seal is correctly
positioned between the cap and the
reservoir body.
Refit the safety clip.