EasyManua.ls Logo

Triumph T120 - High Coolant Temperature Warning Light; Alarm;Immobiliser Indicator Light; ABS (Anti-Lock Brake System) Warning Light

Triumph T120
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General information
28
High Coolant Temperature Warning
Light
With the engine running, if the
engine coolant temperature becomes
dangerously high, the high coolant
temperature warning light will
illuminate.
Caution
Stop the engine immediately if the high
coolant temperature warning light
illuminates. Do not restart the engine
until the fault has been rectified.
Severe engine damage will result from
running the engine when the high
coolant temperature warning light is
illuminated.
Alarm/Immobiliser Indicator Light
This Triumph motorcycle is
installed with an engine immobilizer
which is activated when the ignition
switch is turned to the OFF position.
If the motorcycle is installed with a
genuine Triumph accessory alarm, the
immobilizer will operate as normal but
the alarm/immobilizer light will operate
as described below.
With Alarm Equipped
The alarm/immobilizer light will only
illuminate when the conditions
described in the genuine Triumph
accessory alarm instructions are met.
Without Alarm Equipped
When the ignition switch is turned to
the OFF position, the alarm/immobilizer
light will flash on and off for 24 hours to
show that the engine immobilizer is on.
When the ignition switch is turned to
the ON position the immobilizer and the
indicator light will be off.
If the indicator light remains on it
indicates that the immobilizer has a
malfunction that requires investigation.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified.
ABS (Anti-Lock Brake System)
Warning Light
The ABS warning light illuminates
to show that the ABS function is not
available. Illumination is normal after
engine start up, and until the
motorcycle first reaches a speed
exceeding 6 mph (10 km/h). Unless there
is a fault, it should not illuminate again
until the engine is restarted.
If the warning light becomes illuminated
at any other time while riding it
indicates that the ABS has a
malfunction that requires investigation.
Warning
If the ABS is not functioning, the brake
system will continue to function as a
non-ABS braking system. Do not
continue to ride for longer than is
necessary with the indicator light
illuminated. Contact an authorized
Triumph dealer as soon as possible to

Table of Contents

Related product manuals