Triumph T120 - Page 127

Storage
127
Preparation after Storage
Install the battery (if removed) (see
page115
).
If the motorcycle has been stored for
more than four months, change the
engine oil (see
page81
).
Check all the points listed in the Daily
Safety Checks section.
Before starting the engine, remove the
spark plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter motor
several times until the oil pressure light
goes out.
Replace the spark plugs, tightening to
15lbft (20 Nm), and start the engine.
Check and if necessary correct the tire
pressures (see
page107
).
Check and if necessary adjust the drive
chain tension (see
page89
).
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.