ASSEMBLY STEPS
1. PREPARATION
• Before assembling please check whether all the required parts have been supplied as per the exploded
drawing on the opposite page.
STEP 1
STEP 1:
Open the carton, remove all the parts and place the
Main Frame on level ground.
STEP 2:
Lift the Computer Frame upwards. Using 5# Allen Key
(12), Bolt M8*16 (55) and Lock Washer (67), secure the
Computer Frame on the Right and Left Uprights.
Note: Do not squash the wires inside the tube. Ensure
that wires are connected. When locking the Bolts, please
hold the Upright Tubes, to avoid them falling down.
STEP 2
To Next Page
Loading...
