20
Chapter 6: Plumbing 2503 Center Console • Owner’s Manual Supplement
Freshwater System Winterization
1. Turn On the water system switch.
2. Open the faucet and let the water system drain completely.
3. Turn Off the water system switch.
Any remaining water must be removed from the water lines. There are two ways to remove the remaining water from
the lines:
• Compressed Air
• Gravity Draining
Compressed Air
You must have an air compressor with an air hose
and an air nozzle.
1. Remove the water line from the outlet side of
the water pump (opposite side from filter).
2. Open the faucet.
3. Place the air nozzle against the end of the just
removed water line and blow air through
the system.
4. When water stops coming out of the Open fau-
cet, stop the air and Close the faucet.
Gravity Draining
1. Open the faucet.
2. Remove the drain plug from the tee fitting on
the freshwater tank.
3. When the water has stopped draining from the
freshwater tank, replace the drain plug.
CAUTION!
WATER SYSTEM DAMAGE HAZARD!
Never blow compressed air through the water system when all of the faucets are Closed.
!
FRESHWATER TANK
FILTER
WATER PUMP
OUTLET SIDE
WATER LINE
INLET SIDE
WATER LINE
DRAIN PLUG
TEE FITTING
TYPICAL VIEWNOTE: LOCATION OF
TEE FITTING & DRAIN
PLUG MAY VARY
To Next Page
Loading...
