NOTE
The latitude and longitude display, showing the location of
the measurement, is available only on the PaveTracker
Plus gauges equipped with the GPS option and is shown
only when this option is enabled.
The latitude and longitude value denote the quality of the
location fix. If WAAS information is available during a
measurement, the latitude and longitude will be displayed
to the nearest hundredth (1/100) of a second.
If a GPS location is determined, but the WAAS information
is unavailable, the latitude and longitude will be displayed
to the nearest tenth (1/10) of a second.
If the GPS receiver cannot determine a location, the
latitude and longitude will be denoted as O. For more
information on GPS accuracy, see Appendix D.
NOTE
If the gauge goes into sleep mode, the display returns to
the
Ready screen. To exit sleep mode and continue taking
measurements, press the
〈ENTER/START〉 key.
To Next Page
Loading...
