Troxler PaveTracker Plus 2701-B - Page 57

Model 2701-B
4–9
5. Press 〈ENTER/START〉 to continue. Repeat the steps
above to take a measurement at up to 30 test locations.
When all locations are complete, press the
〈STORE〉 or
〈ESC〉 key to continue.
If the 〈ESC〉 key is pressed, the gauge displays:
Press 〈NO〉 to return to the Ready screen without storing the
results or
〈YES〉 to continue as described below.
If the 〈STORE〉 key is pressed at the end of the measurements
(or if the operator presses
〈ESC〉 then 〈YES〉), the gauge
displays:
When storing test results, the gauge can also store project
notes, such as location information, with the measurement
data. To include project notes, press
〈YES〉. The gauge
displays:
Enter any desired information (up to eight characters) and
press
〈ENTER/START〉. The gauge stores the last displayed
results and notes under the active project and returns to the
Ready screen. For more information on storing measured
data, see the Storing Data section on page 5-10.
End of Meas ur ement
Do You Want To
St or e ?
<YES> or <NO>
Do You Want To
Add Not es?
<YES> or <NO>
I nput Locat i on
Pr ess <ENTER>
4. USING THE GAUGE