25
4.1.1.4 Print Mode: (Tear Off Mode/Batch Mode/Peeler Mode)
This option is used to set the print mode. Printer default setting is Batch Mode.
When enter this list, the print mode in the right side of ¨ icon is the printer
current setting. Press button under ª and © icon to select the different
print mode, and press button under “V” icon to enable the setting.
Printer Mode Description
Tear Off Mode:
Next label leading edge is aligned to the print head burn
line location.
Batch Mode:
Once image is printed completely, label gap/black mark will
be fed to the tear plate location for tear away.
Peeler Mode: Enable the label peel off mode.
4.1.1.5 Offset:
This option is used to fine tune media stop location. Press the button
under ¨ icon to move the cursor from left digit to right digit, and press the
button to set the value from “+” to “-” or “0” to “9”. Press the button under
“V” icon to set the value into printer. The default value is +000.
4.1.1.6 Reference X & Reference Y:
This option is used to set the origin of printer coordinate system horizontally
and vertically. Press the button under ¨ icon to move the cursor from left
digit to right digit, and press the button under ª icon to set the value from
“0” to “9”. Press the button under “V” to set the value into printer. The
default value is 000.
¨Batch Mode
Peeler Mode
ª © V
Offset
+000
¨ ª V
Reference X
000
¨ ª V
Reference Y
000
¨ ª V
To Next Page
Loading...
Need help?
General
