TSC MB241 Series - Loading the Media in Peel-Off Mode (Optional)

27
3.5 Loading the Media in Peel-off Mode (Optional)
1. Open the media cover and
load the media.
2. Release the lever to open
the printhead.
3. Install the label as indicated.
(Pass the label over the top of
guide bar and under the
damper, through media sensor,
and label guide.)
4. Adjust the position of the media sensor and the label guide to fix
the media position.
5. Close the printhead.
Using the front display panel to perform a calibration for the media
first. For touch LCD, press icon to calibrate the sensor. For
2.3” LCD, refer to Sensor section for more information.
Note:
Calibrate the sensor before loading the media in the peel-off mode to
avoid the paper jam.
6. Set the print mode to the Peeler Mode. Refer to Setting section.
(Setting > Print Mode)
Note:
The Print Mode can also be set through the Driver or the TSC Console.
Media Sensor
Label Guide
Media Guide Bar