TSC MB241 Series - Configuring the Printer and Setting Options for the Linerless Media

69
6.10 Configuring the Printer and Setting Options for the Linerless Media
1. After loading the linerless media into the printer, perform the calibration to calibrate the media sensor (Continuous).
2. When the calibration is finished, enter the printer LCD Menu to configure the linerless printer.
Select Setting. Make sure the Command Set is set to TSPL.
For linerless tear module, select Print Mode and set the print mode to Peeler Mode.
For linerless cutter module, select Print Mode and set the print mode to Cutter Mode.
Note:
The Print Mode can also be set through the Driver or the TSC Console.