TSC MB241 Series - Loading the Media in Cutter Mode (Optional)

30
3.6 Loading the Media in Cutter Mode (Optional)
1. Open the media cover, the
printhead, and the cutter
module.
2. Refer to Loading the Media
section to load the media and
make it under go through the
cutter paper entrance.
3. Close the printhead
and the cutter
module.
4. Using the front display panel to perform a calibration for the media.
For touch LCD, press icon to calibrate the sensor.
For 2.3” LCD, refer to Sensor section for more information.
5. Set the print mode to the Cutter Mode.
Refer to Setting section. (Setting > Print Mode)
Note:
The Print Mode can also be set through the Driver or the TSC Console.
6. Press the FEED button to test the operation of the cutter.