TSC MB241 Series - Diagnostic

66
6.8 Diagnostic
The illustration and table below describe the functions in the Diagnostic menu.
Item
Description
Print Config.
Print current printer configuration to the label. The configuration printout contains printhead test pattern, which is useful for
checking the dot damage on the printhead heater.
Dump Mode
Captures the data from the communications port and prints out the data received by printer. In the dump mode, all characters will
be printed in 2 columns. The left side characters are received from your system and right side data are the corresponding
hexadecimal value of the characters. It allows users or engineers to verify and debug the program.
Note: Dump mode requires 4” wide paper width.
Printhead
Check printhead’s temperature and bad dots.
Display
Check LCD’s color state.
Sensor
Check sensors intensity and reading state.
Diagnostic
Print Config.
Dump Mode
Print Head
Display
Sensor