For WPA-Personal
I. Fill-in the SSID.
II. Select the Encryption option to WPA-Personal.
III. Fill-in the Key.
IV. Select DHCP to ON. (For OFF option, please fill-in the IP
Address, Subnet Mask and Gateway)
V. After setting, click the Set button.
Note:
Before setting, the entered field will be shown in yellow for reminding.
On DHCP, user can change the printer name by another model name in
“Printer Name” field.
User also can change the raw port in “Raw Port” field.
For WPA-Enterprise
I. Fill-in the SSID.
II. Select the Encryption option to WPA-Enterprise.
III. Select DHCP to ON (For OFF option, please fill-in the IP
Address, Subnet Mask and Gateway)
IV. Select the EAP Type option. (For EAP-TLS option, please
upload the CA and Key for mutual authentication, integrity-
protected cipher suite negotiation, and key exchange
between two endpoints.)
V. After setting, click the Set button.
Note:
Before setting, the entered field will be shown in yellow for reminding.
On DHCP, user can change the printer name by another model name in
“Printer Name” field.
User also can change the raw port in “Raw Port” field.
To Next Page
Loading...
