TSC TDP-225 Series - Loading External Media (for TDP-225;324 Model Only)

9
3.3 Loading External Media (For TDP-225/324 model only)
1. Open the printer’s top
cover and separate the
media holders to fit the
media width. Press
down the media holder
lock switch to fix the
media holder.
2. Feeds the media through
the rear external label
entrance chute
3. Place the paper,
printing side face up,
through the media
guides, media sensor
and place the label
leading edge onto the
platen roller.
4. Close the top cover gently
and make sure the cover
latches securely, calibrating
the printer by hardware or
software. (Refer to
Chp.4&5)