Appendix D: Software
Appendix D: Software
The QUESTemp 48N Heat Stress Monitor has the flexibility to be set up and controlled
through computer software. The programmable start and stop time feature is only accessible
through the computer. The instrument also has the capability of sending live data while
measuring. These features are best utilized using TSI Detection Management Software DMS.
DMS quick overview
The focus of this section is to briefly introduce the following QSP-II topics: Downloading your
data, setting up parameters, and viewing your data in charts, graphs, and reports. (For further
details on DMS, refer to the online Help and select Contents.)
Communicating and Downloading in DMS
In order to download, review the data, and setup parameters in DMS software, this will require
connecting the QT⁰48N to a computer. The steps below explain connecting and
communicating to DMS.
1. Using a TSI cable, part number 054-715, plug the cable into the computer and plug the
opposite end into the side jack of the QT⁰ 48 data port.
QT⁰ 48 data port
Connected and powered on
Figure 1-32: Communicating with the QT⁰ 48N and DMS
2. From the start page of DMS, select button and the instrument
communication panel will appear.
3. Select Heat Stress and then select the Model Type by clicking on QT⁰48N. (See
Figure 1-34).
To Next Page
Loading...
Need help?
General
