4 Getting Started
Turning on, Logging/Capture an Event, and Turning Off
Turning on, Logging/Capture an Event, and Turning Off
To quickly get you started with the QUESTempº 48N, the following section explains turning on
the instrument, data logging/event logging, and stopping.
1. Press the I/O Enter key to turn on.
The first two start-up screens detail the name, type of instrument, and then a
revision and battery power screen appears. (Ensure the battery level does not fall
below 6.4V or you will want to replace the battery. See “Power options” for more
details.)
NOTE: If you have data saved on the instrument, an additional screen stating “data
in memory” will appear prompting you to reset the instrument, if desired.
A B
Figure 1-3: Start-up screens (A – indicates model and type
B- indicates revision and battery power)
2. In the Index Start-Up screen, press I/O Enter key.
NOTE: If an index is selected from the Setup menu, this will appear on this screen.
Figure 1-4: Index start-up screen
3. A Log Rate Start-Up screen will appear, press I/O Enter key. (This screen details your
log rate time or event logging setup option and the last saved logged session or event.)
(See Setup for more information on event logging.)
Figure 1-5: Log rate start-up screen