TuffStuff CLH-300 - Step 3: Housing Frame Attachment

CLH-300 Horizontal Plate Load Leg Press/Hack Squatwww.tu stu tness.com
ŘŘ
Řŝ
ŘŚ
řŚ
Řś
Řř
Șř
Step 3
14
Step 3 Assembly List
Item # Description Qty.
*3 LINEAR SHAFT HOUSING FRAME 1
22 FLAT WASHER SAE Z/P 3/8” 2
23 FLAT WASHER SAE Z/P 1/2” 3
24 SPLIT LOCK WASHER Z/P 3/8” 2
25 SPLIT LOCK WASHER Z/P 1/2” 3
27 HEX HEAD CAP SCREW GR-5 Z/P 3/8-16 X 1 2
34 HEX HEAD CAP SCREW GR-5 Z/P 1/2-13 X 1 1/2 3
Loosely Tighten
70%
Loosely Tighten
70%
Loosely tighten all hardware in this step.
DO NOT Fully Tighten. Some component(s)
may need pre-assembly and or alignment
during the assembly process.
NOTE:
1. SLIDE THE CARRIAGE TOWARDS THE BACK AND HOLD IT IN PLACE AS SHOWN BELOW.
2. HAVE THE OTHER PERSON BRING THE LINEAR SHAFT FRONT FRAME (#*3) INTO PLACE
WHILE YOU GUIDE THE LINEAR SHAFTS INTO PLACE.
3. BOLT DOWN.