TuffStuff CLH-300 - Rail Wheel Replacement Procedures; Steps 1 & 2: Cable Disconnection and Carriage Removal

CLH-300 Horizontal Plate Load Leg Press/Hack Squatwww.tu stu tness.com20
Rail Wheel Replacement Step 1
Rail Wheel Replacement Step 2
CAUTION:
PLACE A BLOCK UNDER THE FRAME FOR
SUPPORT BEFORE REMOVING THE REAR
STABILIZER.
NOTE:
1. TWO PEOPLE REQUIRED TO PERFORM THESE STEPS.
NOTE:
1. HAVE ONE PERSON HOLD THE LINEAR SHAFTS WHILE YOU REMOVE THE REAR STABILIZER
AND THEN SLIDE THE CARRIAGE OUT.
DISCONNECT THIS END OF THE CABLE
AND PUT ASIDE. (REFER TO PAGE 17)